Aurora Multimedia ASP-CATx1RS Manuel d'utilisateur télécharger pdf (Page 8)

~ 7 ~

1. Connect a HDMI or DVI source (such as a Blu-ray Disc player) to the transmitting unit

ASP-CATX1RS-TX.

2. Connect a HDMI or DVI display (such as a LCD TV) to the receiving unit ASP-CATX1RS-RX.

3. Connect IR Blaster/Receiver to both TX and RX units and or RS-232 connections.

4. Connect a Cat-5/5e/6 cable between the transmitting and receiving units.

5. Make sure this Cat-5/5e/6 cable is tightly connected and not loose.

6. Plug in 5V DC power supply unit to the power jack of the receiving unit ASP-CATX1RS-RX.

7. Plug in 5V DC power supply unit to the power jack of the transmitting unit ASP-CATX1RS-TX.

8. If you see flickering or blinking image on the display, please adjust the rotary control switch to

improve the cable skew. 0 stands for the strongest HDMI signal level for longest possible

transmission length while 7 stands for the weakest HDMI signal level for short transmission

length. Please adjust the signal level from 7 to 0 and stop turning the rotary switch whenever

the audio/video is playing normally. Inappropriate signal level setting may cause overpowering

issue that would shorten the product life significantly!

Hardware Installation

1 2 3 4 5 6 7 8 9 10 11 12

Pas de commentaire

Aurora Multimedia ASP-CATx1RS Manuel d'utilisateur Page 8